Broan best IS502, Instructions Manual

Page: 5 / 48

- 5 -
FUSE REPLACEMENT
FUSE
MAINTENANCE
GREASE FILTER
IF LIGHTS FAIL TO OPERATE, DISCONNECT
THE POWER AT THE SERVICE ENTRANCE.
CHECK THE FUSE AND REPLACE IF NEC-
ESSARY.
1.
Remove the grease filter. Fig. 4.
2. Unscrew the fuse holder cap and remove
the fuse.
3. Replace the fuse with the same size and
amperage (5 x 20mm, 4 amp, 125 volt).
4. Reinstall the filter and connect power at
service entrance.
Grease Filter
The grease filter should be cleaned
after every 30 hours of operation. This
range hood has an operation timer
which will alert you after every 30 hours
of use (the led of the“light button” comes
on).
Use a warm detergent solution. Grease
filter is dishwasher safe.
To take off the grease filter remove the
2 screws. Fig. 5.
Hood Cleaning
Stainless steel is one of the easiest materials to keep clean. Occasional care will
help preserve its fine appearance.
Cleaning tips:
●
Hot water with soap or detergent is all that is usually needed.
●
Follow all cleaning by rinsing with clear water. Wipe dry with a clean, soft cloth
to avoid water marks.
●
For discolorations or deposits that persist, use a non-scratching household
cleanser or stainless steel polishing powder with a little water and a soft cloth.
●
For stubborn cases, use a plastic scouring pad or soft bristle brush together
with cleanser and water. Rub lightly in direction of polishing lines or "grain" of
the stainless finish. Avoid using too much pressure which may mar the surface.
●
DO NOT allow deposits to remain for long periods of time.
●
DO NOT use ordinary steel wool or steel brushes. Small bits of steel may
adhere to the surface causing rust.
●
DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds
to remain in contact with stainless steel for extended periods. Many of these
compounds contain chemicals which may be harmful. Rinse with water after
exposure and wipe dry with a clean cloth.
Painted surfaces should be cleaned with warm water and mild detergent only.
Glass Cleaning
Use a soft cloth and a glass cleaning solution only!
DO NOT use abrasive cloths, steel wool, or scouring pads.
DO NOT use strong cleaning solutions or abrasive powders.
FIG. 4
FIG. 5