Page 3
ALLURE
®
QS1 SERIES
RANGE HOOD
PREPARE THE HOOD
3 Remove
Wiring Cover
from inside the hood. Set cover and
mounting screw aside.
4
Remove either top or back wiring knockout and install
approved
Electrical Cable Clamp
.
WIRING
COVER
ELECTRICAL
CABLE CLAMP
AIR CHUTE
PREPARE THE HOOD
5 Remove
Light Panel
— held in place with (3) no. 8 screws
and (2) no. 8 screws. Disconnect light assembly wire
harness (white connector).
(3) NO. 8 SCREWS
LIGHT
PANEL
Ducted Installation
—
Skip to Step 10.
The following Steps (5 thru 9) are for
NON-DUCTED INSTALLATION ONLY.
9
Re-install air chute and screw, re-connect wire harness,
and replace light panel.
NOTE: Be careful not to trap wires between
Support Fin
and light panel.
7 Remove
Baffl e
from air chute.
Tabs
will
disengage
from
Slots
.
8 Rotate
baf
fl
e. Reinsert
baf
fl
e into air chute (as
shown) so that baf
fl
e
fi
ts all the way into air
chute. An audible
“click” will be heard
when fully installed.
This will direct air
fl
ow through the
non-ducted slots
on top of hood.
(2) NO. 8 SCREWS
TABS
BAFFLE
SUPPORT FIN
6 Remove
Air Chute
- held in place with
one (1) screw.
NOTE: Be careful
not to
disconnect
any wires.
SLOTS
