Broadcom
LPeHBAs-IG126-100
20
Emulex Host Bus Adapters
Installation Guide
The following table summarizes POST conditions and results.
NOTE:
For the link rate conditions, a 1s pause occurs when the yellow LED is off between each group of fast blinks (2, 3,
4, or 5, depending on the HBA). Observe the LED sequence for several seconds to be sure you have correctly
identified the pattern.
2.5 Changing the PCI Device ID Jumper Setting
NOTE:
This section applies to LPe12000-series HBAs only.
The PCI device ID jumpers on LPe12000-series HBAs are used in custom applications. Do not change the jumper settings
for a standard Emulex installation.
NOTE:
Emulex HBAs contain electronic components that can be damaged by static electricity through an ESD event. To
prevent ESD damage, maintain constant contact with any metal grounded surface. A grounding wrist strap is useful
for this purpose. Handle the card carefully at all times, preferably by the edges. Avoid touching electronic
components, and keep the card in the original packaging until you are ready for installation.
Table 14: POST Conditions and Results
HBAs
Yellow LED
Green LED
State
All
Off
Off
No SFP module is installed or a boot failure occurred (dead board)
All
On
Off
POST failure (dead board)
All
Slow blink
Off
Boot failure after POST
All
Flashing
Off
POST processing is in progress
All
Off
On
Failure in the common code module
All
On
On
Failure in the common code module
LPe35000-series
3 fast blinks
On
Normal (link up at 8GFC)
4 fast blinks
On
Normal (link up at 16GFC)
5 fast blinks
On
Normal (link up at 32GFC)
Fast blink
Fast blink
Beaconing
LPe32000-series and
LPe31000-series
2 fast blinks
On
Normal (link up at 2GFC) (LPe31000-series only)
3 fast blinks
On
Normal (link up at 8GFC)
4 fast blinks
On
Normal (link up at 16GFC)
5 fast blinks
On
Normal (link up at 32GFC) (LPe32000-series only)
Fast blink
Fast blink
Beaconing
LPe16000-series
1 fast blink
On
Normal (link up at 2GFC) (LPe15004 only)
2 fast blinks
On
Normal (link up at 4GFC)
3 fast blinks
On
Normal (link up at 8GFC)
4 fast blinks
On
Normal (link up at 16GFC) (LPe1600
x
only)
Fast blink
Fast blink
Beaconing
LPe12000-series and
LPe1250
2 fast blinks
On
Normal (link up at 2GFC)
3 fast blinks
On
Normal (link up at 4GFC)
4 fast blinks
On
Normal (link up at 8GFC)
Slow blink
Slow blink
Offline for download
All
Off
Slow blink
Normal (link down)
Summary of Contents for Emulex LPe12000 Series
Page 50: ......
