X7-8-Install-IG100 Installation Guide
Brocade
®
X7-8 Director Hardware Installation Guide
swDir:admin> ipAddrSet -cp 0
Enter the required information at the prompts. Following is an example configuration for setting the CP0 IP address.
swDir:admin> ipaddrset -cp 0
DHCP [Off]:
Host Name [cp0]:
Ethernet IP Address [10.0.0.0]:192.168.1.2
Ethernet Subnetmask [255.0.0.0]:255.255.260.0
Gateway IP Address [10.0.0.0]:10.38.160.1
IP address is being changed...
Done.
4. Set up the CP1 IP address by entering the
ipaddrset -cp 1
command:
swDir:admin> ipAddrSet -cp 1
Enter the required information at the prompts. The following is an example configuration for setting the CP1 IP
address.
Following is sample configuration for setting the CP1 IP address:
swDir:admin> ipaddrset -cp 1
DHCP [Off]:
Host Name [cp0]:
Ethernet IP Address [10.0.0.0]:192.168.3
Ethernet Subnetmask [255.0.0.0]:255.255.230.0
Gateway IP Address [10.0.0.0]:10.38.160.1
IP address is being changed...
Done.
Establishing an Ethernet Connection to the Device
After using a serial connection to configure the IP addresses for the device, you can connect the active CP blade to the
local area network (LAN).
NOTE
Connecting the CP blades to a private network or VLAN is recommended.
After establishing an Ethernet connection, you can complete the device configuration using a serial console connection,
telnet connection, or management applications, such as Web Tools or Brocade Network Advisor.
Perform the following steps to establish an Ethernet connection to the device.
1. Remove the shipping plug from the Ethernet port on the active CP blade.
The active CP is indicated by an illuminated blue LED on the blade front panel.
2. Insert one end of an Ethernet cable into the Management (MGMT) Ethernet port.
3. Connect the other end to an Ethernet 10/100/1000 BASE-T LAN.
4. Complete any additional device configuration procedures for the device using one of the following steps:
•
Log on to the device using a serial console connection and
admin
logon.
•
Log on to the device through a telnet session using the chassis management IP address and
admin
logon.
X7-8-Install-IG100
51
Broadcom
Summary of Contents for Brocade X7-8
Page 212: ......
