G730-Install-IG100 Installation Guide
Brocade
®
G730 Switch Hardware Installation Guide
Attaching the Rear Brackets to the Rack
Perform the following steps to attach the rear brackets to the rack:
1. Select the proper length bracket for your post width. If your posts are 3 inches to 5 inches wide, use the brackets
marked 3-5 INCH. If your posts are 5 inches to 6 inches wide, use the brackets marked 5-6 INCH.
2. Position the right rear bracket in the right rear of the device.
3. Attach the bracket to the right rack upright using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use the
upper and lower holes in the bracket.
4. Repeat Steps 2 and 3 to attach the left rear bracket to the left rack upright.
5. Tighten all the 10-32 x 5/8-in. screws to a torque of 29 cm-kg (25 in.-lb).
Figure 20: Attaching the Rear Brackets to the Rack
1. Retainer Nuts, 10-32
2. Rear Brackets
3. Screws, 10-32 x 5/8-in. Panhead Phillips
G730-Install-IG100
38
Summary of Contents for Brocade G730
Page 94: ......
