Instructions for Installation & Use
- Series No. 8000/B/2010
Instructions for Installation & Use
- Series No. 8000/B/2010
28
HOW TO SETUP
To be used with either a lap-sash seatbelt or an add-on accessory child harness by children whose
shoulders are above the lower shoulder height marker with the head restraint in the lowest position
(approximately 4 years of age) until their shoulders reach the upper shoulder height marker with the
head restraint in the highest position (approximately 6 to 8 years of age).
Continue to use this child restraint until child reaches the limit. Children are safest in a booster seat
until their shoulders reach the upper shoulder height marker of the booster seat.
Do not use in this mode until the shoulders reach the middle shoulder height marker.
THIS RESTRAINT MUST BE USED IN CARS WITH FORWARD-FACING SEATS WITH A LAP-SASH SEAT
BELT OR WITH A SEAT BELT AND CHILD HARNESS.
THIS BOOSTER SEAT MAY ONLY BE SUITABLE FOR USE WITH A CHILD HARNESS IN THE UPRIGHT
POSITION. IN THE RECLINE POSITION, THE CAR'S SEATBELT MAY NOT BE LONG ENOUGH.
CHILD USE
(BOOSTER SEA
T MODE)
29
HOW TO SETUP
CONVERTING THE TODDLER RESTRAINT INTO BOOSTER SEAT
To use this child restraint as a booster seat the harness needs to be stored under the cover.
Disengage and remove the seat belt from the restraint.
You will need to remove the upper anchorage strap from the anchor fitting when converting to a
booster seat.
Upper anchorage strap must always be used in this booster position when re installed.
If fitted, remove all comfort accessories from the restraint.
STORING ACCESSORIES IN SEAT RECESS
When used as a Booster seat, the SLIDEGUARD™ converter is found in storage recesses under the
cover, as shown below and is connected to the buckle to form the SLIDEGUARD™Clip.
Toddler Use
Child Use with
SLIDEGUARD™ clip
SLIDEGUARD™ converter
Place rolled-up Harness strap
and Harness Tongue in recess
CHILD USE
(BOOSTER SEA
T MODE)
Suitable only for use with Safe-n-Sound™Protecta PLUS™harness series 220/2010 or
Babylove Ezygo Harness™ series BL220/2010 child harnesses.
DO NOT USE WITH JUST A LAP BELT. You must use with a lap-sash belt or with a seat belt and child
harness. If used with a child harness, the lap strap of the seat belt must be adjusted firmly first and
then the harness, so that the lap strap is not lifted off the child’s lap when the harness is adjusted.
ALWAYS USE THE SLIDEGUARD™ CLIP IN BOOSTER SEAT MODE.
Do not use the restraint without the Upper Anchorage Strap correctly attached.
Do not use with the integral harness when in booster mode.
This integral harness must be stored (see page 30-31).
Do not use in a front seat, unless it has a child restraint anchorage point.
Do not use on any vehicle seat which faces sideways or rearwards.
WHERE AN AIRBAG IS FITTED IN THE SEATING POSITION WHERE THE CHILD RESTRAINT IS TO BE
FITTED, FOLLOW THE VEHICLE MANUFACTURERS WARNINGS AND INSTRUCTIONS.
Do not use with just a lap seat belt (unless using a Child Harness - refer to page 39-52).
