REFRESH
INSTALLATION, OPERATION AND MAINTENANCE MANUAL
Maintenance
Step 2:
To empty the grease into the container, remove the slot head drain screw from the
grease drainage hole.
Step 3:
Once the grease has been removed, dispose of the container.
Step 4:
Replace the slot head screw back into the grease drainage hole.
4.2.3.3 Cleaning the Lighting (Refresh Ultima)
Refresh Ultima canopies are fitted with LED type lights.
Clean the lighting as follows:
Step 1:
Switch
OFF
the Refresh Unit lighting.
Step 1:
Switch
OFF
and isolate the electrical power supply.
Step 2:
Allow the LED lighting to cool down.
WARNING:
USE SUITABLE AND APPROVED EQUIPMENT WHEN WORKING AT HEIGHT.
WARNING:
YOU SHOULD WEAR SUITABLE GRIPPING, CUT-RESISTANT WORK-GLOVES WHEN
HANDLING AND CLEANING THE REFRESH UNIT.
Step 3:
Safely position suitable access equipment. Using the cloth moistened with the water
and mild detergent, wipe the diffuser clean.
Step 4:
Using a clean cloth moistened with the water, wipe the diffuser again to remove the
detergent.
Step 5:
Switch
ON
the electrical power supply.
Step 6:
Switch
ON
the Refresh Unit lighting.
4.2.3.4 Cleaning Down Visible Refresh Unit Surfaces (All Units)
Step 1:
Switch
OFF
the Refresh Unit lighting (Ultima only).
Step 2:
Switch
OFF
and isolate the electrical power supply.
Step 3:
Allow the stainless steel surface to cool.
WARNING:
USE SUITABLE AND APPROVED EQUIPMENT WHEN WORKING AT HEIGHT.
WARNING:
YOU SHOULD WEAR SUITABLE GRIPPING, CUT-RESISTANT WORK-GLOVES WHEN
HANDLING AND CLEANING THE REFRESH UNIT.
Step 4:
Safely position suitable access equipment. Using the cloth moistened with the mild
detergent, clean all surfaces.
Step 5:
Using the bucket and warm water, moisten the clean cloth and rinse all surfaces.
Step 6:
Using a clean dry soft cloth, wipe all surfaces dry.
Step 7:
Switch
ON
the electrical power supply.
Step 8:
Switch
ON
the Refresh Unit lighting.
4.2.3.5 Deep Cleaning the Refresh Unit (All Units)
Grease can be deposited on the non-visible inside surfaces of the Refresh Unit. When allowed to
build up, this can increase the risk of fire and reduce the hygiene standards of the equipment. A
deep clean procedure is recommended to reduce this build-up of grease.
Step 1:
Switch
OFF
the Refresh Unit lighting (Ultima only).
Issue: Final
Page 39 of 70
Summary of Contents for Refresh Maxi
Page 71: ......
