5
3
1
4
Pack Contents
Installation Instructions
& User Guide
Prior to Installation
Installation
Please leave these instructions
with the end user
Product Code: VAL2 BAS C CD (D2)
All products manufactured and supplied by Bristan are safe
provided they are installed, used correctly and receive regular
maintenance in accordance with these instructions.
This product has been tested to the Water Regulations Advisory
Scheme (WRAS) and satisfies the requirements of the Water
Supply (Water Fittings) Regulations 1999 and current bylaws.
For full Installation Requirements & Notes (IRN)
please visit
wras.co.uk/directory.
We recommend isolation valves to be fitted to the inlet water
supplies to ensure ease of future maintenance.
Before installing these taps the water supply must be thoroughly
flushed in order to remove any swarf, solder etc.
This product must not be modified in any way as this will
invalidate the guarantee.
2
Adjust so the
horizontal rod
sits comfortably
straight. Tighten
the screws to
secure in place.
Fit the waste
body to the
basin, ensuring
the washers are
in place.
6
To replace any spare parts
for your tap, why not
scan the QR Code or
visit
www.bristan.com
and search for your product.
Spare Parts
Flexible Tail Positions
1/2” BSP
Flexible Tails
Screw the
flexible tails and
fixing kit rod to
the tap base by
hand only.
DO NOT
OVERTIGHTEN
.
Connect the
flexible tails
to the hot and
cold water
supplies.
x1
x1
x1
x1
x2
x1
x1
x1
x1
x1
Feed the tap
body through
the basin hole,
ensuring the
plinth is in place.
IMPORTANT
Turn on w
ater
supply f
or a few
minutes and check
all joints and
connections f
or
any leak
s.
Secure the tap
body using
the fixing kit.
Push the vertical rod through
the back of the basin tap.
Connect the lower rod to
the vertical rod.
Screw the horizontal arm on
to the waste body, ensuring
the washer is in place.
Use the
pop-up link to
connect the
vertical and
horizontal rods.
Slight
bend
90 °
angle
Kinks
Curved
round
Twists
1.0
5.0
Pressure
BAR
0.2
4.0
2.0 3.0
Pressure
BAR
1.0
5.0
0.2
4.0
2.0
3.0
Specifications
Maximum Static Pressure: 10.0 bar
Inlet Water Temperature
Inlet Connections
Min: 0.2 bar
Max: 5.0 bar
Dynamic Water Pressure
Tools You’ll Need
Crosshead
Screwdriver
Flat Head
Screwdriver
Adjustable
Spanner
Long-Nosed
Pliers
Pipe Cutter
60
°
C
65
°
C
60-65
°
C Recommended
REMEMBER
Use flat-faced
isolation valv
es
to isolate the
water supplies
.
REMEMBER
Hot on the
left, cold on
the right!