Briot emotion, Operation Manual

Page: 49 / 210

Using your Edger... General principles of use
3-48
3.2.4.2 I
NSERTING
/ R
EMOVING THE LENS
3.2.4.2.1 T
O INSERT THE LENS IN THE EDGING CHAMBER

When all the edging characteristics have been entered, insert the lens in the edging chamber.

Always check that the correct clamping adaptors for the job have been fitted.
If the job being run requires special adaptors, a warning message will be displayed automatically.
3.2.4.2.2 T
O REMOVE THE LENS FROM THE EDGING CHAMBER
When the edging cycle is stopped or interrupted, open the visor.

Press this button .
Result: the lens clamp shaft opens automatically.

Remove the edged lens without removing the block so as to be able to do a retouch if necessary.
3.2.4.3 S
TARTING
/
INTERRUPTING AN EDGING CYCLE
3.2.4.3.1 T
O START AN EDGING CYCLE
When all the edging characteristics have been entered and the lens is fitted on the lens holder
adapter,

press this button .
Result: The visor closes automatically; the lens clamp shaft closes automatically; the edging cycle is
run.
3.2.4.3.2 T
O INTERRUPT AN EDGING CYCLE
If you wish to interrupt the current edging cycle,

press this button .
Caution! Do not confuse it with the machine shut-down procedure which is activated with this button:
19 mm diameter adaptors
25 mm diameter adaptors