Briot emotion, Operation Manual

Page: 140 / 210

Maintenance... Regular maintenance of the edger
5-139
5.7.5 C
LEANING
/
REPLACING THE REMOVABLE VISOR
5.7.5.1 P
RELIMINARY REMARKS
> Before undertaking any operation, ensure that the machine is switched off: On/Off switch OFF
and mains plug disconnected.
5.7.5.2 R
EPLACING THE VISOR
5.7.5.2.1 P
ROCEDURE
To replace the visor, proceed as described above. Only Step 6 changes.
5.7.5.3 H
INTS
> Regular cleaning of the visor increases the visibility of the interior of the edging chamber and the operations
under way.
> Operating in closed circuit mode affects the cleanliness of the visor. We recommend more frequent cleaning
of the visor.
# 6 Insert a new removable visor in the holder.
# 1 Loosen the 4 screws of the outer visor.
# 2 Apply pressure on either side of the visor to unclip it.
# 3 Remove the inner visor using the slide.
# 5 Clean the inner visor then insert it in its holder.
# 7 Tighten the 4 screws of the outer visor.