Brillcam Inc. Copyright 2020-2021
Page 47 , Total 83
•
IP Address
: it
’
s allows the user to set Lan network
’
s IP address.
•
DHCP
: it allows the user to use the DHCP mode or not for the Lan network.
•
Subnet
: it alows the user to set the sub net address for the IP address of the Lan network.
•
Gateway
: it allow the user to set the gateway IP address of the Lan network.
•
PoE address
: it allows the user to set the PoE network address if it
’
s the POE NVR.
•
Main DNS
: it
’
s allows the user to set the main DNS address of the Lan network.
•
Sub DNS
: it alows the user to set the secondry DNS address of the Lan network.
•
Refresh
: it
’
s allows the user to refresh the working settings.
•
Default
: it alows the user to click to restore all parameters to the default value.
•
Apply
: it allows the user to apply the settings.
•
Cancel
: it allows the user to cancel the settings.
3.2.2
P2P settings
The user can select the
“
P2P
”
tab to set the P2P parameters for mobile access.
After set the NVR
’
s network connection to make sure that the NVR is connected to the Internet successfully,
then the user can start the mobile monitoring through this page.
•
Install APP:
it can be scanned by the mobile to download and install the Android APP or IOS APP;
•
Device ID:
it is used for the mobile to add the NVR into the mobile APP by scanning this QR code.
Please check the detailed information from the APP user guide.
•
Enable:
it allows the user to enable or disable the mobile accessing ability.
•
Stauts:
it shows the NVR
’
s internet connection status. If it
’
s offline, it means the NVR is not connected
to Internet successfully.
•
Refresh:
it allows the user to refresh the NVR Internet connection status.
Apply:
it allows the user to save the settings.
Cancel::
it allows the user to give up the settings.