BRIGHT BLUE COLIBRI RX, Quick Start Manual, Page: 4 / 15

©Copyright FR-V2016
Les informations contenues dans ce document peuvent être modifiées sans préavis.
3
1 Safety Instructions
This product is a combination of an electronic controller and the respective accessories. It
has been assembled and tested according to the safety measures applied to electronic devices in
the EC. It has been cleared by the quality department within the factory. To preserve status and
guarantee operation safety, the following instructions must be observed.
Only licensed personnel must execute product installation.
Electrical installation must be done according to local electrical safety regulations.
Product connection to the power line must allow for total isolation (phase, neutral and
earth) to ensure safe repair and maintenance operations. A differential switch with a maximal earth
fault current of 30mA should shield all circuitry.
Before turning on the controller it is recommended to verify its physical conditions as well
as the circuitries. In case of installation in a warmer place than origin leave the controller’s door
open to stabilize temperature and avoid condensation of the electronic components.
When the controller is turned on remember to let the capacitors discharge before handling
them to avoid electric shock.
1.1 Warnings
Risk of Electrocution
The controller’s components carrying electrical tension, which might lead to
electrocution, are signaled with the following symbol:
The performance of any electrical operation by unauthorized personnel is entirely
forbidden. The equipment must be turned off before any maintenance operation.
Risk of human failure
Product operation should follow adequate training to all personnel handling the
equipment. Special attention must be paid to electrical and chemical safety
measures before using the equipment.
2 EC Conformity
The manufacturer declares, that the electronic equipment for pool water treatment of its
production are in compliance with the technical requirements:

EN 50274:2002

IEC 60335-1:2006

IEC 60947-1:2007

IEC 62026-1:2007
and the EC directives:

Low Voltage Equipment Directive 2006/95/CE

Electromagnetic Compatibility Directive 2004/108/CE.
3 System Contents
This equipment is supplied with the electronic controller, electrolysis cell and a temperature
sensor (Colibri version only).