14
15
PIC. 9B
PIC. 9A
PIC. 10
FILL CAP
FILL CAP
LEFT/RIGHT
SELECTOR
Adding Lubricating Oil
Always use clean fresh oil as specified on page 9. Incorrect
or old oil can cause the pressure washer to run rough and
damage the motor; this will not be covered by warranty.
1. Ensure that engine is OFF when filling oil.
2. Remove oil plug, see Pic. 9A
3. Use oil as detailed on page 9 (SAE 30W or SAE 15W-40
4 Stroke Motor Oil).
4. Ensure pressure washer is level when filling with oil.
DO NOT TIP / USE A FUNNEL (Not Supplied).
5. Only fill oil to the top of the thread, Pic. 9B.
6. Ensure that the oil filler cap is screwed on tightly before
attempting to start the pressure washer.
Warning:
Over filling the oil can damage the pressure
washer, this damage will not be covered under warranty.
Detergent Tube and Bottles (PIC. 10)
Connect the detergent tube, push the tube fully onto
the nipple.
This model pressure washer comes with twin 800ml
detergent bottles, you can use the same detergents in both
or different ones in each.
Fill the detergent bottle/s and turn the selector to the
bottle you wish to use.
Note: The detergent will only flow when the low pressure
black nozzle is used and the motor speed is reduced.
OIL
LEVEL
