Service & Troubleshooting Guide - Home Generator System - Models 040213 and 040234 (15kW)
Section 1 - General Information
Page 11
1
SECTION 1 - GENERAL INFORMATION
ACCESS TO THE GENERATOR
The 15kW Home Standby Generator System is equipped
with an enclosure that has three access doors (Fig.1).
The doors are named for the significant component(s)
located behind them. Starting with the side that has the
fuel connection and proceeding clockwise, the doors are
named:
• Oil Fill Door
• Control Panel Door
• Oil Drain Door
Each Home Standby Generator System is equipped with
two identical keys. These keys fit all the doors.
To remove an access door:
• Insert a key into the lock of the access door you
wish to remove and turn one quarter turn
counterclockwise.
• Open the latch with a quarter turn
counterclockwise.
• Open the door enough to clear its jambs and lift
the door from its hinges.
NOTE
: When removing more than one door at a
time, it’s a good idea to mark the doors for proper
fit when reinstalling.
To install an access door:
• Mount the door hinge barrels on their respective
pins and close.
• Turn latch a quarter turn clockwise.
• Lock the door with the key.
Fig. 1 - Generator Access Doors
CAUTION
: Do not operate the standby
generator for extended periods without all the
doors installed and closed. Failure to do so will
cause overheating.
Fuel Inlet Fitting
Lifting Holes
Oil Fill Door
Control Panel Door
Oil Drain Door
Summary of Contents for 40213
Page 3: ...Page 3...
Page 4: ...Page 4...
