35
8
System Information
8.1
Version Information
Device Name
is a pre-populated field to help identify the MDR unit. The two available
options that will be displayed is either MDR-504XX-500 or MDR-508XX-1000.
Serial Number
is a unique identifier for each MDR unit. This information is used to
connect a mobile network or Wi-Fi MDR to MDR-Dashboard. This is made up of 10
alphanumeric characters.
MAC Address
refers to media access control address which is a unique identifier.
This is assigned to network interfaces for communications at the data link layer of a
network segment. This consists of 12 alphanumeric characters.
Firmware Version
refers to the firmware which contains the OSD menu. The
structure follows: MDR-504_VXXX_TXXXXXX.XX or MDR-508_VXXX_TXXXXXX.XX.
MCU Version
refers to microcontroller firmware which is installed in the MDR unit.
This firmware controls all hardware operations. Such as the HDD heater. This is made
up of 9 alphanumeric characters.
Version Information Figure 119
8.2
Modules
8.2.1
Mobile Network
This tab will only show if enabled and configured.
Connection Type
shows the connection used to connect to network operators.
The options are: GPRS/EDGE, CDMA, EVDO, WCDMA, TDSCDMA, FDD and
TDD.
Module Status
shows whether the MDR sees the presence of the mobile
network module. This will say detected or not detected.
SIM Status
shows whether the MDR sees the presence of a SIM card. The
statuses are detected, not detected, available, not available and busy.
Dial Status
indicates the SIM’s dial status, which can be dialled up, failed dial up
and unknown error.
Signal Level
will display the power level of the signal, this will be xxdBm format.
IP Address
refers to the IP address obtained by the SIM from the network
provider.
IMEI
refers to International Mobile Equipment Identity number. This is made up of
15 alphanumeric characters.
Mobile Network Figure 120
8.2.2
Wi-Fi
This tab will only show if enabled and configured.
Built-in Wi-Fi Status
indicates the current physical state of the internal Wi-Fi
module. This can be detected, not detected, connecting, connection failed,
connected and obtaining IP address (DHCP).
Signal Level
will display the power level of the signal in a visual form
. The
more blue bars the better the signal level.
IP Address
refers to the IP address obtained by the wireless module.
MAC Address
refers to media access control address which is a unique
identifier. This is assigned to network interfaces for communications at the data link
layer of a network segment. This consists of 12 alphanumeric characters.
SmrtCntrllr Wi-Fi Status
is unused currently.
SmrtCntrllr SSID
is unused currently.
SmrtCntrllr IP Address
is unused currently.
SmrtCntrllr MAC Address
is unused currently.
Wi-Fi Figure 121
Summary of Contents for MDR-504-500
