Bridgeview Bale King 6100, Operator'S & Parts Manual

Page: 31 / 65

Bale King 6100 – Operator and Parts Manual 31 / 65
Troubleshoot guide
Problem Possible Cause Remedy
Excessive main shear bolt
breakage
Engaging PTO at high engine
speed or too quickly
Idle tractor to engage PTO then bring up to full
operating speed
Feather PTO lever into position
Excessive twine wrapped on
rotor causing flail
movement to be restricted
Cut twine off rotor
Broken flails causing rotor to be
out of balance
Replace broken flails (in pairs opposite each
other)
Overloading rotor Set hoops to less aggressive position
Slow rotation of bale
Change direction of bale rotation
Incorrect shear bolt used Use correct shear bolt
Operating machine at less than
1000 PTO RPM
Operate machine at rated 1000 PTO RPM
Excessive vibration while
processing bales
Excessive twine wrapped on
rotor causing flail
movement to be restricted
Cut twine off rotor
Broken flails causing rotor to be
out of balance
Replace broken flails (in pairs opposite each
other)
Overloading rotor Set hoops to less aggressive position
Slow rotation of bale
Change direction of bale rotation
Operating machine at less than
1000 PTO RPM
Operate machine at rated 1000 PTO RPM
Rotor bearing failure Replace failed parts
Agitators stopping
Excessive loose material in tub
causing agitator to jam
Reverse direction of bale rotation
Turn bale more slowly
Tractor relief pressure set too
low
Set tractor relief pressure to at least 2500 psi
A single agitator stopping
Mechanical flow divider valve
not functioning correctly
Contact your dealer for repairs
Coupler between motor and
agitator broken
Replace failed parts
A single chain stopping Mechanical flow divider valve
not functioning correctly
Contact your dealer for repairs
Sprocket is broke Replace failed parts
The chain might be off the idler
wheel
Put the chain back on and tight the chain
Deflector or Tilt doesn't
move.
The control box is not plugged
in.
Plug in the control box
The fuse in the control box is
failed.
Replace the fuse