Page 7
BrickHouse Security User’s Guide
Page 8
BrickHouse Security User’s Guide
Recording Video
Move the Power Switch to the ON position. The Power
Indicator and Detect Indicator should both be lit. To set up
motion-triggered recording from the device, press the Detect
button. The device will beep once and the Detect Indicator
will blink and turn off. If motion is detected, the indicator will
blink once. To stop motion-activated recording, press the
Detect button again. The device will beep and the Detect
Indicator will turn on to let you know that any recordings have
been saved.
To use the remote control be sure it is pointed at the Remote
Control Receiver on the clock’s face. Press the REC button
to start recording constant video. The clock will beep twice
to indicate it has started recording. Press the STOP button
to stop recording and save the file. Press the TRIGGER ON
button to set the device to motion-activated recording. The
clock will beep twice to indicate that it has entered motion
activation mode. Press TRIGGER OFF to return the device to
standby mode. It will beep once.
When motion trigger is active, the device will automatically
begin recording when something moves within range of
the camera. The trigger will store video 3 seconds before
motion was detected until 15 seconds after motion stops.
Videos will automatically be stored every 15 minutes if
motion is continuous.
