39
First Menu
Level
Mode Number
Second
Menu
Level
Value
Range
Mode Description and Instructions
show real time, while the third displays may be a timer with external control that
requires active Up and Down buttons. The remote could be used to access any of the
displays. In this scenario, if one of the real time displays is accessed, you may see
activity on the timer because the Up and Down buttons would be active on both the
real time display and the timer.
See also, Mode 32-55, Mode 32-42 and Mode 32-49.
37
33
0-99
Radio Power On Period
0=5 sec (default)
1-99 = seconds to power the radio
This mode determines how long the battery powered radio in analog clocks will
remain on before going to sleep mode. By default, the mode is set to zero which flags
the radio to remain powered for 5 seconds. This allows enough time to obtain a time
update and repeat five time update packets, while maximizing battery life. However,
it is too little time to gain control over the air to reprogram the device. If the radio
needs to be reprogrammed over the air, set Mode 37-33=30. This will keep the radio
powered for 30 seconds which should be enough time to reprogram the radio. Once
programming is complete, return Mode 37=33 to 0 to maximize battery life in the
analog clocks. This mode requires RC100 Tiger version 1.20 or later and analog
clock radio firmware version 1.8 or later.
37
63
0,1
Message Board Time Updates
0=disabled (default)
1=enabled
This mode enables time update transmissions to message boards. Updates are sent
hourly at 2 minutes and 10 seconds after the hour.
37
65
0-99
Wireless/Ethernet Sync Indicator Delay
5= (default)
This value determines the number of minutes between a change in sync status and
resetting the sync status indicator.
37
76
0-3
Wireless Analog Clock Movement Support
0 =activate full time reception only on the days of DST (default),
This setting is for Chouchin or Shengbang movements with the hands installed at the
10:00 position, and Mode 37-62=9. If Mode 37-62=9 then on the day to switch from
ST to DST or DST to ST, and the previous day, no transmissions will occur if the
hour is less than 2 or greater than 19.
1= activate full time reception once per month on the 1st,
If Mode 37-62=7 or 9 then on the first day of the month, no transmissions will occur
when the hour equals 0, 22, or 23.
2= activate full time reception twice a month on the 1st and 15th,
If Mode 37-62=7 or 9 then on the first and fifteenth day of the month, no
transmissions will occur when the hour equals 0, 22, or 23.
3= activate full time reception every day.
If Mode 37-62=7 or 9 then everyday, no transmissions will occur when the hour
equals 0, 22, or 23.
