30 / 36
2. **Here, you must enter the UV gain factor (found on the battery compartment of your sensor). For
more information about UV sensor calibration, see section "UV Sensor calibration".
3. Press "Apply" to finish the setup.
4. The base station will now connect to the router you have specified. When the connection is suc-
cessful, the status LED will turn blue.
Wi-Fi requirements
1. Supported devices: Smart devices with built in Wi-Fi with AP mode function, laptops or PCs.
2. Wi-Fi Standard: 802.11 b / g / n, supports AP Mode
3. Web browser: Browsers that support HTML 5
Router requirements
Wi-Fi Standard: 802.11 b / g / n
Supported security type: WEP, WPA, WPA2, open (for routers with no password)
15 UV Sensor calibration
The example picture shows a gain factor of 1.7. You can find the correct UV gain factor on the battery
compartment of your sensor. This value must be specified when setting up the station.
