25 / 32
NOTICE! When switching from mains power supply to battery power supply or vice versa,
the power supply is being disabled for a short moment for technical reasons. Exception: per-
manent battery operation.
Remote sensor
1. Remove the battery compartment cover.
2. Insert the batteries into the battery compartment. Ensure that the battery polarity (+/-) is correct.
3. Set the channel selector switch to the desired channel.
NOTICE! This weather station can be operated with one or more remote sensors. Each re-
mote sensor being connected must be operated on a different channel. If only one remote
sensor is connected, it should be operated on channel 1.
4. Replace the battery compartment cover.
9 Automatic time setting
After the power supply was established, the clock will automatically search for the radio signal. The
clock will automatically search for the radio signal.
If the radio signal is received correctly, the date and time will be set automatically and the radio control
signal icon turns on.
If the clock fails to receive the time signal, go ahead with the following steps:
1. Press RCC button at the remote sensor for approx. 2 seconds to initialize the radio signal recep-
tion again.
2. If the device is still not receiving the signal, the time must be set manually.
Read the detailed manual for more information about manual time and alarm setting (see download in-
formation on page 2).
10 Manual time setting
1. Press and hold TIME SET button for approx. 3 seconds to change to time setting mode.
2. Digits to be set are flashing.
3. Press +/CHANNEL or -/MEM button to change the value.
4. Press TIME SET button to confirm and continue to the next setting.
5. Settings order: 12/24-hours mode > Hours > Minutes > Year > Month (M) and Day (D) / Day (D)
and Month (M) > Month > Day > Time offset > Time signal reception (RCC) ON/OFF > DST (Day-
light Saving Time) AUTO/OFF > Weather forecast animation ON/OFF
6. Finally press the TIME SET button to save the settings and exit the setting mode.
11 Alarm setting
1. Press and hold ALARM button for approx. 3 seconds to enter the alarm time setting mode.
2. Digits to be set are flashing.
3. Press CH/+ (UP) or MEM/- (DOWN) button to change the value.
4. Press ALARM button to confirm and continue to the next setting.
5. Settings order: Hours > Minutes
6. Finally press the ALARM button to save the settings and exit the setting mode. Alarm will be activ-
ated automatically. The symbol will be displayed.
7. Press ALARM button in normal display mode to display the alarm time.
8. Press ALARM button during the alarm time display to disable the alarm.
