4
Before Use:
1.
Carefully remove your heater from its shipping container.
2.
Ensure that your heater’s Power Control Switch is in the ‘O’ position.
3.
Place your heater on a firm, level surface. Completely uncoil the power cord, and connect
your heater directly into a120 Volt outlet.
CAUTION: Ensure that the plug fits tightly into the electrical outlet. A loose fit can cause
overheating and damage the plug.
NOTE: The power cord and the plug may feel warm during normal operation.
NOTE: The power cord has a polarized plug (with one blade wider than the other) that will
only fit in a polarized outlet one way. If it does not insert easily try reversing the plug. If it still
does not fit contact your electrician to replace your outlet.
DO NOT defeat the safety purpose of the polarized plug.
CAUTION: TO PREVENT ELECTRIC SHOCK MATCH WIDE BLADE OF PLUG TO
OPERATION
1.
Place the heater on a flat, level and stable surface.
2.
Plug the heater into a 120V AC electrical outlet. The power indicator light will illuminate to
tell you the heater is turned ON.
3.
Turn the control switch from OFF position (0) clockwise to the desired heat setting.
(LOW): heating up to 330W
(MEDIUM): heating up to 660W (HIGH): heating up to 1000W
4.
When the heater is not in use, set the control switch to the 0 (off) position and unplug
from the wall socket.
HEAT SAFETY FEATURES
Safety grill: The heater is equipped with a safety grill at the front to protect the heating elements.
This part of the heater can get extremely hot. Do not block this grill as it could cause fire.
Tip-over switch: The heater will be automatically shut off by a built-in safety switch when it is
tipped over. If this occurs, turn the heater OFF, unplug it, put the heater back to upright position
and plug it back in.
Overheat protection: The heater is equipped with a safety shut -off device.
If the heater grill is obstructed, or if the heater gets too hot for any reason, the device will
automatically shut the heater off.
To reset the heater, simply turn power off and unplug the heater for 10 minutes until it cools
down, they you may plug in and operate normally.
CLEANING AND MAINTENANCE
WARNING: Always unplug the cord before moving or servicing, maintenance.
Do not immerse heater in water.
1.
Unplug the heater from the power source and let it cool down
2.
Do not remove grill guard or allow heater to be operated without grill guard in place.
3.
Clean the body with a clean, soft lightly damp cloth to gently wipe off the dirt from the surface
of the heater. You may use a mild detergent if necessary. After cleaning, dry the unit with a soft
cloth.
