24 Using the iSleep 20
iSleep 20 clinician’s manual
Doc. 003923 En-Us V-2
5
Using the iSleep 20
5.1 Checking the iSleep 20 before Use
Always make the following checks before using the iSleep 20:
1
Connect a cleaned or a new patient circuit to the iSleep 20.
2
Connect the iSleep 20 to the AC supply.
3
Check patient settings.
4
Switch on the iSleep 20 by pressing the Start/Stop button on the front
panel. Ensure that the iSleep 20 is running.
5
Put on the mask and adjust its fit.
6
Ensure that the settings are adjusted as prescribed.
The iSleep 20 is ready for use.
5.2 Switching the iSleep 20 On and Off
The iSleep 20 is connected to a power supply when the LCD display is lit up.
1
Make sure the power supply
is connected.
2
Turn on the iSleep 20 by pressing
the Start/Stop button on the front
panel for 2 seconds.
This operation switches the iSleep 20
between standby and operating
mode.
