Operating instructions
ECOM
ix
• The software used has been checked for operational safety and no fault conditions should arise
as long as the equipment is operated properly and runs correctly. Nevertheless, operators
should regularly check that the program is running correctly and take the unit out of service
in case of any possible faults and to inform technical support.
Inform technical support in case of obvious technical defects or external damage and
do not put the device into operation.
"
Call the Service-Hotline: see chapter 11
3.4 Protection from electrical hazards
Work on electrical components should be performed only by experts.
Always keep the cabinet closed. Access must be allowed to authorised personnel only.
For detailed information on electrical safety devices, see the Technical Data.
3.5 Emissions/EMC
The system does not cause vibration or dust.
The electronic components of the system are protected from disturbances, such as the following:
1. Pulse-type transients on supply lines
2. Interference pulses and high frequency fields
3. Electrostatic discharges
The
ECOM
ix production system is designed according to EMC standards. However,
the influence of electromagnetic radiation or by other devices cannot be ruled out.
3.6 Maintenance
Required maintenance and inspection work must be carried out in a timely manner.
The electrical safety devices should be checked regularly.
For maintenance purposes, the system must always be brought into a safe operating condition.
The
ECOM
ix production system has sensitive control and monitoring components
that must be tested or calibrated at regular intervals.
3.7 Modifications of the equipment
No changes, extensions or alterations to the system may be made without the manufacturer’s per-
mission.
The different functional modules may not be changed.
All changes to the system require the manufacturer’s written consent.
22
State: April 2021
4.9.1., I Manual ECOMix Original (EN), 7, F: M. Lorek, 06.04.2021