![Braun A5S1-n Series Manual Download Page 33](http://html.mh-extra.com/html/braun/a5s1-n-series/a5s1-n-series_manual_2802450033.webp)
A5S1-n-Manual_EN_Rev02 2021_JAN_19
Page 33 of 36
4
Technical Specifications
4.1
Conformity to Standards
EU-Directive(s)
Standard(s)
2014/34/EU
ATEX product directive
EN IEC 60079-0
EN IEC 60079-15
2014/30/EU
EMC directive
EN 61326-1, EN IEC 61326-3-2
2014/35/EU Low voltage directive
EN 61010-1
2011/65/EU
RoHS directive
EN IEC 63000
4.2
Power Supply
Supply voltage: + 6
V… + 30 V DC.
Max. supply current: see certificates from chapter 2.3.
For use in zone 2: see certificates from chapter 2.3.
The sensors of the A5S1...-n series may only be operated in hazardous area zone 2.
Current consumption: approx. 15 mA (one channel sensor) resp. 25 mA (two channel sensor),
plus load (can increase up to 60 mA with long transmission length and high signal frequency).
If powe
r supply isn’t provi
ded by a BRAUN device, a PELV resp. SELV power supply has to be
used.
4.3
Signal Output
Rectangular pulses with constant high level and low level over the entire speed range
.
Push-Pull amplified output. Maximum load 20 mA.
The signal output is short circuit proof and protected against polarity error.
4.4
Speed (Frequency-) Range
Speeds with a maximum signal frequency of:
A5S1DS
…
-n:
0 Hz…12 kHz
A5S1DD
…
-n:
0 Hz…25 kHz
4.5
Signal Transmission
Cable in shielded version LiYCY with 3x0.5 mm
2
, resp. 4x0.5 mm
2
with R < 36 Ohm/km and C <
150 pF/m).
4.6
Electrical Protective Measures
Protection class: no protection needed
IP code:
IP67, pressure-tight stainless-steel housing (1.4305)
4.7
Connection
Connection with screw-plug-in connection (straight or angled) or with fixed PVC (up to 85°C) or
Teflon® (up to 125°C) cable.
4.8
Permissible Ambient Temperature
See certificates from chapter 2.3.
4.9
Installation Dimensions
The sensors are available with different installation threads (D) metric, resp. inch, resp. inch with
NPT, and each with a number of different nominal lengths (L). This is the length from the front
surface of the sensor to the end of the mounting thread (see figures on chapter 7).
Summary of Contents for A5S1-n Series
Page 29: ...A5S1 n Manual_EN_Rev02 2021_JAN_19 Page 29 of 36 Figure 18 EAC Ex TR CU Certificate part 2...
Page 30: ...A5S1 n Manual_EN_Rev02 2021_JAN_19 Page 30 of 36 Figure 19 EAC Ex TR CU Certificate part 3...
Page 31: ...A5S1 n Manual_EN_Rev02 2021_JAN_19 Page 31 of 36 Figure 20 EAC Ex TR CU Certificate part 4...