INSTALLATION INSTRUCTIONS
1. Disconnect lift power wire and remove cover from lift.
2. Mount receiver at least two feet away from lift with screws provided
in a location where the antenna is not obstructed by the vehicle
walls.
3.
(NL955 and NVL955)
Connect the 5-position connector to J3 on
the Intermotive Accessory Board (100362-001). Connect the 4-pin
connector from J4 on the Intermotive Accessory Board to J11 on the
lift control board as shown on Figure 1.
4.
(NV05 and NMV05)
Connect the 5-position connector to J3 on the
Intermotive Accessory Board (100285-001). Connect the 4-pin
connector from J4 on the Intermotive Accessory Board to W14 on
the lift control board as shown on Figure 1.
5. Remove cover on receiver 100381-001. Confirm that multi-function
is selected (P1 on receiver board).
6. Before placing your 100381-001 remote into service,
the receiver
and transmitter codes must be set to match or the unit will not
function.
We urge you to personalize your codes, in order not to
interfere with neighboring systems, and to provide security for your
own system. You will note that the transmitter has two, ten position
code switches (see Figure 2 and 3). We strongly urge that several
coding schemes be avoided: ALL ON; ALL OFF; 2, 4, 6, 7, 8,
10 ON; 1, 3, 5, 7, 9 ON. These positions are similar with assembly
test positions, or are frequently used. Set the receiver and trans-
mitter (side A and B) code switch positions 1-9 to match (see Figure
2 and 3). The 10
th
position on your transmitter code switches are
used for channel selection. Channel 1 on the receiver is selected
by moving the 10
th
position of the transmitter side A to the off
(open) position. Channel 2 is selected by moving the 10
th
position
of the transmitter side B to the on (closed) position. Once the
codes are set, check the operation and replace the transmitter/
receiver covers.
7. Reconnect lift power wire and reinstall cover on lift.
Page 2
32978
Rev. A
