Braukmann CASO DESIGN 1371, Original Operating Manual

Page: 39 / 108

39
 Sealing profile (which presses the bag against the sealing bar)
Remove the sealing profile and clean it in warm soapy water.
Please note
► The sealing profile should be cleaned thoroughly before installing it again.
► Be careful during re-installation, so that nothing will be damaged and sealing profile is
placed well so that the device can work properly.
18 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
18.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
18.2 Cause and Action
In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Error Possible cause Rectification
Vacuum unit is not
functioning
Power plug is not plugged in Plug in mains plug!
Defective power cable or plug Send device to Customer Service
Defective electrical socket Select another electrical socket
The first weld on the
cut off piece of the roll
is not being carried
out.
Roll is not positioned
correctly
Follow the steps in the chapter
“Vacuum packaging in a bag
originating on the roll”
A complete vacuum is
not being created in
the bag.
The open end of the bag is
not completely inside the
vacuum chamber
Position the bag correctly
The bag is defective Select another bag
There is dirt on the welding
and the normal seals Clean the seals and retry
correctly once they are dry
The bag is not being
welded correctly The welding bar is
overheating so that the bag
melts
Open the cover on the unit and
let it cool down for a few minutes