Branson 2000X ao, Instruction Manual, Page: 91 / 112

100-214-281 Rev. 07 6-1
2000X ao Actuator Chapter 6: Operation
Instruction Manual Actuator Controls
Chapter 6: Operation
6.1 Actuator Controls - - - - - - - - - - - - - - - - - - - - - - - 6-1
6.2 Initial Actuator Settings - - - - - - - - - - - - - - - - - - - - 6-2
6.2.1 Regulated Air Pressure and Air Pressure Gauge - - - - - - 6-2
6.2.2 Factory Air Source - - - - - - - - - - - - - - - - - - - - - 6-3
6.2.3 Downspeed Control - - - - - - - - - - - - - - - - - - - - 6-3
6.2.4 Dynamic Trigger - - - - - - - - - - - - - - - - - - - - - - 6-3
6.2.5 Actuator Alignment and Height (Horn travel) - - - - - - - - 6-4
6.2.6 Mechanical Stop - - - - - - - - - - - - - - - - - - - - - - 6-4
6.2.7 Emergency Stop - - - - - - - - - - - - - - - - - - - - - - 6-5
6.3 Operating the Actuator - - - - - - - - - - - - - - - - - - - - 6-5
6.1 Actuator Controls
This section describes how to operate a weld cycle using the 2000X ao Actuator. For more
detailed information on making and altering settings, refer to your 2000X-series Power Supply
manual.
WARNING
!
When setting up and operating the Actuator, observe the following precautions:
Keep hands away from under the horn. Down force (pressure) and ultrasonic
vibrations can cause injury.
Plastic parts can vibrate within the audible frequency range when welded. If this
occurs, use hearing protectors to prevent possible injury. Do not allow the ultra-
sonically activated horn to touch a metal base or a metal fixture.