Branson 2000X ao, Instruction Manual, Page: 49 / 112

100-214-281 Rev. 07 4-5
2000X ao Actuator Chapter 4: Installation and Setup
Instruction Manual Handling and Unpacking
4.2.3 Stand (Actuator on a Hub)
Figure 4.2 Unpacking the Stand (Actuator on a Hub); Hub Shown Separately
CAUTION
!
Heed the “This End Up” arrows and the “Open Top First” instructions. The packaging is
designed to be removed from the assemblies from an upright orientation only.
1. Move the shipping container close to the intended installation location, leave it on the floor.
2. Cut the two vertical packing straps, and open the top of the box. Remove the insert from the top of
the box, which can contain the booster, converter, and the toolkit. Set the insert box aside.
3. Remove the staples at the bottom of the protective box. Lift the protective box off the pallet. Flatten
the box and lay it next to the pallet (you will lay the stand on it soon).
CAUTION
!
The unit may tend to tip over. Stabilize the stand using the lifting hook or an assistant.
4. Cut the packing strap securing the column support to the pallet.
CAUTION
!
The column and column support are under spring tension from the counterbalance spring. Do
NOT attempt to disassemble the column from the stand, but always keep the column support
clamped together. When making height adjustments, carefully and slowly release the clamps
to control the motion, and hold the stand to prevent sudden movements or injury.
Converter
Tool Kit
Booster
6-1/2in.
18in.
Shipping
Strap
53 in.
Block of wood
for shipping
32-1/2in.
Insert Box
Protective
Box
Hub
(shipped in place
on column, on pallet)
Two Hub Bolts
(loosen to remove
Hub from Column)
Note: Hubs may be lag-bolted to the
pallet for shipping purposes.