Branson 2000X ao, Instruction Manual, Page: 74 / 112

4-30 100-214-281 Rev. 07
Chapter 4: Installation and Setup
Rack Mount Installation
NOTE i
i
Do not permanently remove the Cover from the Power Supply because it is
required for proper system cooling.
Figure 4.16 Detail of Rack Mount Handle Kit Assembly
Step Procedure
1
Order and obtain the Rack Mount kit for your Power Supply. The brackets in the Kit are
designed for standard 19-inch rack mounting options.
2
From the front corners of the Power Supply, remove the Front Corner bezels by removing
the two Phillips screws. Save the screws.
3
Noting that one side of each bracket is countersunk to accept the provided flathead
screws, assemble the Rack Mount Handles as shown in
Figure 4.16 ’Detail of Rack
Mount Handle Kit Assembly’ on page 4 - 30 . (This shows only the Right bracket and han-
dle; the left side is a mirror-image.) Tighten the screws securely and so they are flush.
4
Re-using the screws you removed in Step 2, install the assembled Handle in place of the
Front Corner pieces.
5
Save the removed hardware corner pieces.
6
When you are ready to install the unit, use the hardware from your Rack Mounting system
to locate the Power Supply.
Insert two flat-head screws
through the bracket and
into each handle, as shown
Right-side Rack Mount handle
Rack Mount bracket
(right side shown)