pro-alpha
infinity
Setup instructions
.
1)
Make sure the door is working freely by hand, and there are no children, pets, obstructions etc in the garage which
may get hurt during the set-up.
2)
Engage the door to the traveler by opening or closing the door
slowly
by hand to the traveler while the release lever
is in the horizontal position.
3)
Connect and move closed limit switch well back to the machine head so that it is not activated when the door is
closed.
4)
Connect the mains power by means of the kettle cord provided.
5)
Insert fuse to connect batteries. (see note below)
6)
Jog the door to about +/- 300mm off floor with the “UP” or “DOWN” button.
7)
Press and hold (about 3seconds) “SET” button until “BLUE” LED flashes.
8)
Jog door down to the ideal closed position. You can fine-tune the position using the “UP” button as well.
9)
Once satisfied with the position, slide the limit switch towards the trip button on the end of the chain. When the
switch is activated the flashing “BLUE” LED will stop flashing and stay on.
10)
Press and hold the “SET” button until the “BLUE” LED starts flashing again. The closed position is now saved into
memory.
11)
Jog the door to the ideal open position using the “UP” button, and if required the “DOWN” button can be used to fine
set the position.
12)
Press and hold the “SET” button again to memorize the open position.
13)
The operator will then automatically run closed and then open. This is to set the door weight parameters into the
program for the safety sensitivity settings. Do not interfere with this cycle! Do not touch the door! The “BLUE” LED
will switch off when the SETUP is complete.
14)
The operator is now ready for normal use.
15)
To comply with international safety standards the maximum force the operator will apply is 20kg. If this is
exceeded the door must be rectified before the operator will work correctly, even if the sensitivity override is
used.
Note
:
In order to conserve the batteries and insure the immediate use of the operator, please remove fuse whenever the
operator is stored, or is going to be without mains supply for 2 days or more.
Fault Indicator Lights:
BLUE “Mode indicator” LED flashes
1)
1 flash pause 1 flash pause -
The operator is in “PROGRAM” mode. (Limit settings)
