BRANNSTROM CleanTrack 1000 B, Operation And Technical Manual, Page: 54 / 232

Brannstrom Sweden AB CleanTrack 1000B - Rev 2.20xd, 2019 Page 54 of 232
7.4. Recorded data
The recording device is formatted electronically as mentioned in MEPC.108(49) chapter 6.9.1.
Recorded date is stored in a non-volatile memory and can hold approximately 3,000,000 printouts which is more than
sufficient to meet the requirements.
Optionally a paper printer can also be installed in the computer unit.
The recorded data should be retained for at least three years.
The recorded data can be copied to a USB-memory stick. See chapter 7.5. USB, page 56.
The "Recorded Data" table shows printouts as specified in MEPC.108(49), chapter 6.9.
The RED "Scroll back! ### sec" is shown if latest printout is not shown on top line. After 300 seconds (5 minutes) of
inactivity, indications will go back to displaying the top line.
The indication (Man) after “Conc”, “Flow”, “Speed” and GPS coordinates indicates that all values are in manual.
The two screenshots above have different (Man) settings.
The indication (Man) after “Conc” also indicate that the Oil Concentration was set to manual before starting for
discharge, thus the sample pump will not be started.
The indication (MaR) after “Conc” indicate that the Oil Concentration was set to manual after starting for discharge, (in
“RUNNING” mode). Then the sample pump is started and normal pressure checks are made.
An activated alarm is indicated with
“/Alarm”.
A deactivated alarm is indicated
with “\Alarm”.
Printout 126627-126624:
Values are set to manual.
Printout 126619-126613:
Standard printout.
Mar.Dist. FO – DMA
Indicate the oil type.
RED “Manual Override”
Indicate a manual setting.
The overboard discharge
control is disabled.
Discharge stops because
the total quantity of oil
discharge has reached is
allowed maximum.
Valve feedback
indicating that the valve
is closed.
Indicating that the top line
is not displayed.