Brandt TI213BS1, Operating Manual

Page: 58 / 124

58
Looking after
sparkers and
injectors
Looking after
your glass top
- If ever the sparkers
get dirty, clean them
with a stiff non-
metallic brush.
- The gas injectors
are in the centre of
each burner in the
form of a "pot".
Make sure not to
block them up
partially when cleaning the hob, as this will
considerably reduce the performance of your
gas-rings.
- Small hard-bristled
brush.
- Clean it with hot water, then wipe dry. Use
special ceramic glass cleaning products for
any persistent stains.
- Household sponge
- Special ceramic glass
products
E.g. Cera-Clen
Looking after
your induction
rings
- Clean them with hot water and wipe dry. If
necessary, finish off with the hard side of a
sponge and wipe dry.
Use special ceramic glass cleaning products for
any persistent stains. (See example below).
- Household sponge
- Special ceramic glass
products
E.g. Cera-Clen
Looking after
the grills and
burners
- Use a non-abrasive cream for removing any
persistent stains. Then rinse with clean
water. Dry each burner element carefully
before re-lighting your hob.
- Non-abrasive cream.
- Household sponge.
HOW TO PROCEED
ACCESSORIES TO
BE USED
Keeping your hob in good condition is easy if you clean it before it is completely
cold . Even so, never clean it when it is in use. Put all the electric and gas control
knobs at zero.
How to look after your hob?
- Should a crack appear on the glass-top, disconnect your
appliance immediately and contact your After-Sales Service.
- It is better to wash the parts of your hob by hand rather than in a dishwasher
-Never use an abrasive sponge (Scotch-brite type) for cleaning your hob.
thermocouple
(depending on model)
Nut
Injector
Sparker
99625701_ML_B.qxd 19/11/04 09:02 Page 58