Brandt TE560 Series, Manual For Installation And Use, Page: 31 / 44

31 31
1 / INSTALLING YOUR APPLIANCE
CHANGING THE GAS SUPPLY
W Wa arrn niin ng g
Y Yo ou urr a ap pp plliia an nc ce e iis s s so olld d p prre e--s se ett ffo orr
n na attu urra all g ga as s..
T Th he e iin njje ec ctto orrs s rre eq qu uiirre ed d ffo orr a ad da ap pttiio on n tto o b bu utta a--
n ne e//p prro op pa an ne e c ca an n b be e ffo ou un nd d iin n tth he e p plla as sttiic c b ba ag g
c co on ntta aiin niin ng g tth hiis s g gu uiid de e..
T Tiip p
IIn n F Frra an nc ce e,, tth hiis s h ho ob b c ca an n a alls so o b be e a ad da ap p--
tte ed d tto o p prro op pa an ne e//b bu utta an ne e--a aiirr g ga as s.. T Th he e a ad da ap ptta a--
ttiio on n k kiitt iis s s su up pp plliie ed d o on n rre eq qu ue es stt b byy yyo ou urr
A Afftte err--S Sa alle es s S Se errvviic ce e D De ep pa arrttm me en ntt..
Each time you change the gas supply, you
must complete the following:
— Adapt the gas connection
— Change the injectors
— Adjust the hob connections
•
A Ad da ap ptt tth he e g ga as s c co on nn ne ec cttiio on n : Refer to the
““G Ga as s C Co on nn ne ec cttiio on n”” section.
•
C Ch ha an ng ge e tth he e iin njje ec ctto orrs s, proceeding as fol-
lows:
— Remove the pan suppor ts, heads and
covers from all burners.
— Using the wrench provided, unscrew the
injectors located under each crucible and
remove them
(Fig. 01).
— Replace with the corresponding gas injec-
tors, in compliance with the placement of the
injectors and the table of gas properties at the
end of this section; to do so:
— First screw them in manually until the injec-
tor locks into place.
— Apply the wrench to the injector as far as it
will go.
— Draw a line on the burner plate using a pen-
cil at the place indicated
(Fig. 02).
— Turn the wrench clockwise until the line
appears on the other side
(Fig. 03).
W Wa arrn niin ng g
E Ex xc ce ee ed diin ng g tth hiis s lliim miitt m ma ayy d da am ma ag ge e tth he e
p prro od du uc ctt..
— Reposition the burner heads, burner covers
and pan supports on the hob.
• •
Tip
Each time you change the gas supply,
tick the box corresponding to the new gas
level on the label found in the plastic bag.
Refer to the corresponding “Gas
Connection” section.
Fig. 02
Fig. 03
Line
Line
Wrench
Wrench
Fig. 01
Wrench
Injector
Crucible