33
•
A d jus t t h e h o b c on ne c t ion s: they are
located underneath the knobs
(Fig. 04).
— Proceed one tap at a time.
— Remove the knobs and the gaskets by
pulling them up.
- Sw it c h i ng f r om na t ur a l g as t o bu t an e /
propane
-
With a small flat-head screwdriver, screw in
all the way the brass (yellow) burner power
screws
(Fig. 05), in a clockwise direction.
-
Replace the gaskets and the knobs, paying
careful attention to their direction and ensur-
ing that the knobs are pushed in all the way.
— Switching from butane/propane to natural
gas
-
Unscrew the brass (yellow) burner power
s c re ws
(Fig. 05), using a small f lat-head
screwdriver, by turning two times counter-
clockwise.
-
Replace the knob,
-
Light the burner in maximum heat mode,
then turn down to reduced heat mode.
-
Remove the knob again, then turn the burner
power screws clockwise until it reaches the
l o w e s t p o s s i b l e s et t i n g t h a t d o e s n ot
extinguish the flame.
-
Replace the gasket and knob.
-
Make several attempts to shift from the max-
imum flow rate to the minimum: the flame
should not go out; if it does, unscrew the
burner power screw so as to obtain good
f l a m e r ete n t i o n d u r i n g t h e s e p o s i t i o n
switches.
1 / INSTALLING YOUR APPLIANCE
Knob
Gasket
Tap
Fig. 05
Tap axis
Fig. 04
Burner power
adjustment screw
Summary of Contents for TE 1416 Series
Page 1: ...GUIDE D UTILISATION Tabledecuisson...
Page 43: ...43 6 NOTES...
