19
a time when of food stocks are low and
proceed as follows:
- Remove existing food and accessories
baskets, unplug the appliance from the
mains power and leave the doors
open. Ventilate the room thoroughly
to accelerate the thawing process.
Caution!
Don't use sharp objects to
remove frost from the refrigerator. Only
after the interior is completely dry should
the appliance be switched back on and
plugged back into the mains socket.
Door seal cleaning
Take care to keep door seals clean.
Sticky food and drinks can cause seals to
stick to the cabinet and tear when you
open the door. Wash the seal with a
mild detergent and warm water. Rinse
and dry it thoroughly after cleaning.
Caution!
Only after the door seals are
completely dry should the appliance be
powered on.
Replacing the LED light
Warning:
The LED light must not be
replaced by the user! If the LED light is
damaged, contact the
customer
helpline for assistance. To replace the
LED light, the below steps can be
followed:
1.
Unplug your appliance.
2.
Remove light cover by pushing up
and out.
3.
Hold the LED cover with one hand
and pull it with the other hand while
pressing the connector latch.
4.
Replace LED light and snap it
correctly in place.
Troubleshooting
If you experience a problem with your appliance or are concerned that the appliance
is not functioning correctly, you can carry out some easy checks before calling for
service, please see below. You can carry out some easy checks according to this
section before calling for service.
Warning!
Don't try to repair the appliance yourself. If the problem persists after you
have made the checks mentioned below, contact a qualified electrician, authorized
service engineer or the shop where you purchased the product.
Summary of Contents for BFL584YNW
Page 144: ......
