15
English
8. Setting the time
To set the daylight saving time, refer to chapter "13 Daylight saving time function"
in this user manual.
Proceed as follows to set the time:
•
Press the "CLK" button and then hold the "SET" button for at least 5 seconds.
•
The day in the display starts flashing. Press the "LEFT" or "RIGHT" buttons
to set these accordingly. Press the "SET" button again to confirm the entry.
•
Next, you need to set the "hour". Then the hour on the display starts to
flash. You can select the desired hour using the "LEFT" or "RIGHT" buttons.
Press the "SET" button once you have set the desired hour.
•
After setting the hour, you need to configure the "minutes". You can set the
desired "minutes" using the "LEFT" or "RIGHT" buttons. Once you finish the
setting, press the "SET" button to confirm.
•
The time is now configured successfully. The timer goes back to the "CLK"
mode (time).
9. Creating the programs
Note: To ensure that the programs are executed properly, make sure that your
configured timers do not overlap. Be especially careful with the "BLOCK" function.
Programs with the command "OFF" are always prioritized over the command "ON".
Likewise, the timer does not primarily detect the priority of the program number
but only the set time. Check the operating mode of the timer if you want to enable
the configured programs. The timer operating mode has to be set to "AUTO". In
addition, it is important to turn off the "RANDOM" and "COUNTDOWN" functions.
Proceed as follows to create a program:
•
Press the "RIGHT" button to display the program menu. In this case, it is
"Program 1_ON". The first "Switch on" program can now be configured.
