Infared Dual Mount Universal CMOS Camera with Optional Gridlines
Installation Instructions
(Kit # FLTW-7611)
7611 Instructions 5-28-14.docx
Page 1 of 3
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in Kit:
Tools & Supplies Needed:
Chassis Harness
¼
” Drill Bit
Power Harness with RCA connectors
Power Drill
Camera mounted on license plate bracket
Multi-meter or computer-safe test light
Small bag containing:
Ground Eyelet (recommended)
Two Screws
Soldering Iron
Allen Wrench
Wire Ties or Electrical Tape
Alternate Camera Mount with Double-sided
Adhesive Foam
Solder (recommended) or T-Taps
Plastic trim removal tool
Instructions
Rubber Grommet or Silicone Caulk
(recommended)
Vehicle service manual (if needed)
Small sheet metal screws (recommended for
Alternative Camera Mount install)
Safety Precautions:
•
Work in well ventilated area that is clear of obstructions.
•
Secure vehicle with tire chucks in both front and rear of tires.
•
Turn vehicle accessories OFF and ensure ignition key is in OFF position.
•
Wear safety goggles and snug fitting clothes.
•
Use tools only for their intended purpose and which are in good repair.
•
Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions. The latest full color
instructions can be accessed at www.brandmotion.com
Step 1: Select and Install Camera Bracket
Determine which of the two supplied camera
mounting methods you prefer.
License Plate Bracket
Alternate Camera Mount Bracket
Place camera in desired position to confirm fitment
(Note: Some states prohibit items blocking the license
plate; check local authorities to confirm legal status for
your application).
If using
License Plate Bracket
, remove license plate.
Reattach license plate securing bracket behind.
If using
Alternate Camera Mount Bracket
, remove
camera from License Plate Bracket using supplied Allen
wrench. Attach camera to the Alternate Camera Mount
bracket and apply supplied self-adhesive foam to mount.
Use the Template included in the Installation
Instruction Overview to position the Alternate Camera
Mount on vehicle
Clean vehicle surface to which mount is to be
attached and affix with self-adhesive foam.
RECOMMENDED: Permanent attachment using screws.
Step 2: Measure, mark, and drill
¼
” hole for
camera harness.
NOTE:
If your vehicle has a liftgate
panel/trunk trim cover, it must be removed.
