Brainlab VectorVision, System User'S Manual

Page: 49 / 110

System User Guide Rev. 1.6 VectorVision 49
VECTORVISION COMPACT NAVIGATION STATION
4.4.2 User Panel Ports
Overview The user panel varies depending on the configuration of your system.
Figure 18
Video 1 & Video 2
Ports If external video equipment is available, plug the BNC cable labeled
Video
into the corresponding
appropriate video camera unit (“Video Out” port).
A video source can be a microscope, an ultrasound machine, endoscope or C-arm with a 50 Hz PAL
or 60 Hz NTSC composite signal.
You can use either
Video 1
or
Video 2
, as the source of the video input is specified later using the
navigation software.
Image Injection
Port To inject images when using a microscope, plug the VGA cable of the
VectorVision compact
into
the VGA connector of the microscope.
Both cables are labeled
Image Injection
.
Microscope Ports To establish communication with:
• Zeiss, Olympus or Moeller-Wedel microscopes, connect the
Microscope Moeller-Wedel /
Olympus / Zeiss
port of the
VectorVision compact
to the corresponding port of the micro-
scope using the supplied cable
• Leica microscopes, connect the
Microscope Leica
port of the
VectorVision compact
to the
corresponding port of the microscope using the supplied cable
VGA Out Port To record the operation on a video, the
VGA out
port of the
VectorVision compact
, connect the
television and/or an external monitor using an appropriate signal converter.
NOTE: The available signal is SXGA 1280x1024 pixels, 60 Hz non interlaced.
Network Port To load patient data via the network, connect the network plug to the corresponding hospital network
plug.