Brainlab KICK 2, System And Technical User Manual

Page: 87 / 136

8.2.2 Test Steps
Measuring Devices
The measurement instructions provided are an example for one measuring device. The individual
steps may vary from one measuring device to another. Refer to the corresponding manufacturer’s
instructions for the measuring device you are using.
NOTE: If you are unsure whether your measuring device is suitable, contact Brainlab support.
Testing Precautions
ME SYSTEM test steps must be performed as described below. The described test only covers
the Brainlab
Kick 2 Navigation Station equipment and not connected equipment. In addition,
follow the directions given by the manufacturer of the connected device.
During measurement, all devices must be in operation mode.
Perform tests in normal condition as well as in single fault condition.
Test Guidelines
When performing recurrent tests:
• Perform required test steps in the order defined.
• Measure all areas of the system indicated in the following chapters.
• All tests must be passed before the device can be considered safe.
• The calibration of the measuring device must be valid at the time of measurement.
• Perform all tests according to IEC 62353.
Safety Inspection Form
All safety tests must be documented. A print out of the safety inspection form can be used as a
basis for this documentation.
• Print out or make a copy of the safety inspection form.
• Enter the inspection results.
• Compare measured values with critical values to determine if the test has been passed.
• Keep form as a record of the inspection.
Required Test Steps for ME EQUIPMENT
Step
1. Visual inspection
2. Protective earth resistance
3. Equipment leakage current
4. Applied Part leakage
5. Functional test
6. Document results
7. Evaluate results
8. Check and prepare for normal use
ELECTRICAL SAFETY
System and Technical User Guide Rev. 1.0 Kick 2 Navigation Station Ver. 1.1 87