BRAILLO
l
B 650 SW2.1
67
4.16
Cutter calibration
The cutter calibration is adjusting the position of the cut related to the printed text on the sheet.
If the cutter calibration is cor
-
rectly adjusted, the cut should be
placed on the sheet like shown in
the figure to the left.
The distance from the cut to the
braille text will be the same on
both sides of the cut.
If the cutter calibration is ad
-
justed too high, the cut will be
placed nearer to the printed text
on the starting edge of the paper.
In this case, lower the value on
the cwutter calibration.
If the cutter calibration is adjust
-
ed too low, the cut will be placed
further away from the printed
text on the starting edge of the
paper.
In this case, increase the value on
the cutter calibration.