Troubleshooting
Printer Diagnostics
Bradyprinter THT X-Plus II Series User Guide
127
FEED and PAUSE Self Test
Performing this self test temporarily resets the printer configuration to the factory
default values. These values are active only until power is turned off unless you save
them permanently in memory.
To perform a FEED and PAUSE self test, complete these steps:
1.
Turn Off (
O
) the printer.
2.
Press and hold
FEED
and
PAUSE
while turning the power On (
I
). Hold
FEED
and
PAUSE
until the
DATA
light turns off.
No labels print at the end of this test.
Communications Diagnostics Test
This test is controlled from the front panel display. See
. The following illustration shows a typical printout from this test. Turn off
the power to exit this self test and return to normal operation.
Additional Printer Diagnostics
Additional diagnostic tests are available for this printer. See the
Maintenance Manual
for information about these additional tests.
Note •
The communications test label prints upside-down.
Summary of Contents for Bradyprinter THT 300X-PLUS
