Control Panel
45
Label Profile
The
Label profile
function carries out a longer label advance. It saves the
values measured by the label sensor here and then prints them out in two
diagrams. The printout is used to check label detection in conjunction with the
optical properties of the label medium.
1. Select the label sensor to be tested in
Setup > Print param.
Refer to
2. Load the label medium to be tested into the printer.
3. Press the
menu
key.
4. Select
Test > Label profile
menu.
5. Press the
key. The printer performs a longer label advance. The label
sensor measures the transparency/reflection capacity of the label
material. The message
Test print OK
appears in the display once the
advance is complete.
6. Load printable material which extends across the entire printing width.
7. Press the
key to start the diagram printout.
You can cancel the printout with the
cancel
key.
Figure 32, Label Profile
