Terreon® Quadra-Fount™ Wall-Hung Washfountain with Adaptive Infrared Control
Installation Instructions
MF2949/IR
9
Bradley Corporation • 215-1249 Rev. H; EN 03-045
9-15-2003
Installation Instructions continued . . .
Step 8: Check Adaptive operation
1. Check to make sure both stop valves are fully open (refer to Figure 2 on page 5).
2. Turn on the main water supply to the Quadra-Fount™ and check for leaking.
3. Pass your hand in front of each sensor until air is purged from the lines.
Step 9: Install top cover
1. Install the threaded rods into the holes on the bottom of the top cover (see Figure 8).
2. Carefully place the top cover with threaded rods on top of washfountain sprayhead.
3. Inside the pedestal assembly of the washfountain (use front access), slide the anchor plate onto
the threaded rods and secure anchor plate against bowl using the wing nuts provided.
Figure 8