Terreon® Quadra-Fount™ Wall-Hung Washfountain with Adaptive Infrared Control
MF2949/IR
Installation Instructions
Bradley Corporation • 215-1249 Rev. H; EN 03-045
6
9-15-2003
Installation Instructions continued . . .
Step 4: Install solenoid assembly
1. Inside the pedestal frame, install the two 1/4-20 x 5/8" screws (supplied with solenoid assembly) in
the mounting holes on the right side of the frame. DO NOT thread the screws completely into the
frame, but allow 5/16" of the screw to be exposed (see Figure 3).
2. Hang the solenoid assembly on the exposed portion of the screws.
Connect Flexible
Hose at this end
Solenoid
Assembly
Pedestal
Frame
1/4"-20 x 5/8"
Screws
Figure 3
Step 5: Install pedestal panels
1. Install three 1/4-20 x 1/2" screws
(provided) on each pedestal panel so
that about 3/16" of each screw is
exposed. DO NOT tighten screws
(see Figure 4).
2. Slide each of the pedestals onto the
frame assembly so that the exposed
portions of the screws fit into the
slots on the frame assembly. Slide the
pedestal panel toward the wall until
the screws fit in the narrow end of the
notches in the frame assembly.
3. Tighten the screws to secure the
pedestal panels to the frame assembly.
Screw
Narrow
End of
Notch
Right
Pedestal
Left
Pedestal
Figure 4