Installation
SN2008/IR
Bradley Corporation
• 215-1069 Rev. G; EN 10-00-015
7-12-2010
5
1
Install and Anchor Unit
Rough-in of plumbing lines must be completed before unit
can be properly installed.
2
Connect Water Supply to Valve Assembly
Hot Supply Inlet
Cold Supply Inlet
Vernatherm TMV
Braided
Hose
Stop/Check Valve
A
Connect 1/2" NPT female end of stop/check
valves to supply lines. Connect supply hoses
to hot and cold inlets of the Vernatherm TMV.
B
OPTIONAL TEMPERED LINE CONNECTION: Connect 1/2" NPT
female end of stop/check valve to supply line. Connect Tempered
line adapter to Gang Valve Assembly as shown.
Do not turn on water
until Step 3 is completed!
A
Remove Access panel and with
the help of another person, place
unit in position.
C
Install a minimum of four 3/8" bolts (supplied
by installer) around unit at the marked
locations (eight is recommended). Secure
unit to fl oor.
B
Ensure unit is level, shimming fl oor unit if
necessary. Using the base as a template,
mark the fl oor anchor locations.
15" (381) Dia.
Water Supply Gang
Valve Assembly
Red Tube
(to Aerator)
Red Tube
(to Aerator)
Green Tube
(to Aerator)
Green Tube
(to Aerator)
Black Tube
(to Aerator)
Black Tube
(to Aerator)
Yellow Tube
(to Aerator)
Yellow Tube
(to Aerator)
OPTIONAL Tempered Line
Adapter Assembly (S39-685)
Water Supply Gang
Valve Assembly