BpTRU BPM100, Manual, Page: 41 / 93

Display Reference
35
Symptoms Possible Causes Corrective Actions
Systolic display
shows software
version number (e.g.,
1.53) and
Pulse and
Reading displays
show varying
numbers.
BpTRU is set to BP
Zero Calibration Check
or BP Reference Gauge
Calibration Check. Exit BP Zero
Calibration Check or
BP Reference Gauge
Calibration Check by
turning power off and
then on again.
Monitor enters low-
power state often or
turns off automatically
( BPM200 & BPM300). Insufficient charging. Charge battery for 12
hours.
End of battery life Replace battery (part #
BPM20036).
Battery charging
indicator remains on
for longer than 24
hours during charging. End of battery life. Replace battery.
BP System Errors (E0 to E15)
If a BP system error occurs during operation, an error
code will be displayed in the
Systolic display only. All
other displays remain blank.
Press the BP Start button to resume measurements.
Code Description Corrective Action
_ _ _ User-cancelled
measurement. None required.
E0 a Too few pulses
detected. Check patient for pulse. Tighten cuff
on arm and check BpTRU
for leaks in
tubing or cuff.
E07 Loss of calibration
data. Contact BpTRU Customer Support.