bpr Rotax 912 i Series, Maintenance Manual, Page: 436 / 458

Effectivity: 912 i Series
Edition 1/Rev. 0
d0
594
1.
fm
MAINTENANCE MANUAL
BRP-Powertrain
79-00-00
Page 14
July 01/2012
ASSEMBLY
OIL PUMP - ASSEMBLY
NOTE:
Whenever the ignition housing is instal-
led or assembled, new acid-free greased
o-rings and other sealing elements must
always be used correctly!
Fig. 15
Fig. 16
Fig. 17
Step Procedure
1 Apply Klueber grease to the plug screw.
2 Screw the plug screw with the pressure
spring and the regulator piston finger-tight
into the oil pump housing.
1. Plug screw 2. Pressure spring DM9.1 D1.0 L65.6
3. Regulator piston
Step Procedure
3 Stick insulating tape over the feather key
groove.
m
WARNUNG
NOTICE
Press in the oil seal so that the closed side
points towards the oil pump housing.
Step Procedure
4 Apply Klueber grease to the oil pump
shaft and push oil seal A 14x22x4 onto
the oil pump shaft while turning slightly.
1. Oil pump shaft 2. Insulating tape
3. Oil seal A 14x22x4
Step Procedure
5 Place the oil pump housing on a firm sur-
face.
6 Remove the insulating tape from the oil
pump shaft.
7 Insert the oil pump shaft with the oil seal
and press it in as far as it will go with a
soft-faced hammer.
1. Oil pump shaft 2. Oil seal
3. Oil pump housing 4. Soft-faced hammer
m
WARNUNG
NOTICE
The oil pump shaft must not be pulled out again,
otherwise the oil seal is unusable.