bpr Rotax 912 i Series, Maintenance Manual, Page: 408 / 458

Effectivity: 912 i Series
Edition 1/Rev. 0
d0
535
5.
fm
MAINTENANCE MANUAL
BRP-Powertrain
76-70-00
Page 28
July 01/2012
Fig. 35
FINISHING WORK ON THE KNOCK SEN-
SOR
Follow the same procedure as removal when
doing this work. See section 76-70-00 Knock
sensor removal – preparation
CRANKSHAFT POSITION SENSOR ASSY.
(CPS_1/CPS_2) - INSTALLATION
Fig. 36
Fig. 37
1. Cable ties
m
WARNUNG
NOTICE
Ensure that the O-ring rests on the sensor.
Step Procedure
1 Push the cable clamp onto the cable.
m
WARNUNG
NOTICE
Arrange the cable so that it does not rest against
the engine suspension frame or other compo-
nents.
1. Crankshaft position
sensor CPS_1
2. Crankshaft position
sensor CPS_2
3. M6x20 allen screw 4. Washer
5. Cable clamp 6. O-ring
Step Procedure
2 Secure M6x20 Allen screw with LOCTITE
243 and tighten it.
Tightening torque 10 Nm (88.48 in. lb.).
3 Plug the respective wiring harness con-
nector into the crankshaft position sensor.
4 Carefully push the connector (CPS) into
the locking plate.
1. Connector (CPS) 2. Locking plate