bpr Rotax 912 i Series, Maintenance Manual, Page: 405 / 458

Effectivity: 912 i Series
Edition 1/Rev. 0
d
053
55.
fm
MAINTENANCE MANUAL
BRP-Powertrain
76-70-00
Page 25
July 01/2012
PRESSURE/TEMPERATURE SENSOR
(AAPTS) - INSTALLATION
TEMPERATURE SENSOR (CTS) - INSTAL-
LATION
Fig. 26
TEMPERATURE SENSOR (MATS) - INS-
TALLATION
Fig. 27
Fig. 28
Step Procedure
1 Follow the aircraft manufacturer's instruc-
tions for assembly.
2 Plug the respective wiring harness con-
nector into the corresponding pressure or
temperature sensor.
See section 76-50-00.
Step Procedure
1 Clean the thread of the temperature sen-
sor.
2 Lubricate the thread of the pressure sen-
sor with LOCTITE 243 and use an SW 19
open-ended spanner part no. 876130 (or
a similar tool) to tighten it.
Tightening torque 15 Nm (88.48 in. lb.).
3 Plug the respective wiring harness con-
nector into the corresponding tempera-
ture sensor. See section 76-50-00.
1. Temperature sensor (CTS)
Step Procedure
1 Clean the thread of the temperature sen-
sor.
2 Fasten the temperature sensor and seal-
ing ring with an SW 19 open-ended span-
ner part no. 876130 (or similar tool).
Tightening torque 15 Nm (88.48 in. lb.).
1. Temperature sensor (MATS) 2. Sealing ring
Step Procedure
3 Plug the respective wiring harness con-
nector into the corresponding tempera-
ture sensor. See section 76-50-00.
4 Attach cable ties (strain relief).
1. Temperature sensor (MATS) 2. Cable ties