bpr Rotax 912 i Series, Maintenance Manual, Page: 190 / 458

Effectivity: 912 i Series
Edition 1/Rev. 0
d0
534
5.
fm
MAINTENANCE MANUAL
BRP-Powertrain
72-30-00
Page 8
July 01/2012
Fig. 8
NOTE:
Mark the installation position of the
push-rod with an appropriate marker
(e.g. a touch-up pen) (e.g. "IV1" for in-
take valve cylinder 1).
NOTE:
If the parts are installed again with the
same position and allocation as befo-
re they were removed, the push-rods
can be reused. The reason for this is
the break-in which takes place on the
parts prior to removal.
Step Procedure
5 Lift the intake manifold with the fuel rail
slightly and carefully pull the entire cylin-
der head off the cylinder with both hands.
6 Hold both push-rods in position in the oil
return bores. Hold the oil bore closed with
a finger and remove the cylinder head.
7 Remove 16x5 O-rings from the oil return
tubes and the crankcase.
m
WARNUNG
NOTICE
Put down the cylinder head in such a manner
that the sealing surfaces and the oil return bores
are not damaged.
1. Cylinder head assy. 2. Push-rod assy.
3. Oil return bore 4. 16x5 O-ring
Step Procedure
8 Hold the oil-filled push-rods closed with a
finger, remove them and put them down
with the corresponding cylinder heads to
prevent confusion.